AllGuard Weatherproof Shield
Outdoor storage and trailering
$139.99
Lifetime WarrantyCare
Check the care label first. Then wash the cover cold on a delicate cycle in a commercial washer, or by hand with a hose, mild soap and a soft cloth, and let it air dry.
To clean a jet ski cover, check its care label first. If the label allows machine washing, wash the cover in cold water on a delicate cycle in a commercial washer with no center agitator, using a mild detergent, and run an extra rinse. To wash it by hand, hose it down, wash it with mild soap and a soft cloth, and rinse it well. Either way, let it air dry fully. Never use hot water, fabric softener or a clothes dryer.
That's our care rule for both of our jet ski covers, the Weatherproof Shield and the Satin Shield. Below: the machine and hand-washing steps, drying, bird droppings, sap and dust, musty smells, and what to avoid.
Read the care label on your cover before you wash it, and follow the label wherever it differs from this page. Our two jet ski covers are made from different fabrics:
| Cover | Fabric | Use |
|---|---|---|
| Weatherproof Shield | 600D solution-dyed polyester with a PU-coated back | Water-resistant and trailerable |
| Satin Shield | 85% polyester and 15% stretch spandex, with a sheared fleece interior | Indoor |
The care steps below are the same for both covers. If you can't find or read the label, contact us before you machine wash the cover.
Use a commercial washer with no center agitator, like the machines at a laundromat, rather than a household washer.
Make sure the care label allows machine washing.
Set the washer to cold. Never use hot water.
Use a mild laundry detergent made for delicates, in the amount its label recommends. Skip harsh detergents and fabric softener.
Choose the delicate setting if the washer has one.
When the cycle ends, run one more rinse.
Take the cover out and let it air dry fully. Never put it in a clothes dryer.

No commercial washer nearby? You can wash the cover by hand while it's on the jet ski.
Put the cover on the jet ski the way you normally fit it.
Fill a bucket with cold or warm water, never hot, and add a mild soap.
Wet the cover with a hose to rinse off loose dirt, dust and droppings.
Soak a soft cloth in the soapy water and wash the whole cover. Use a plain cloth: depending on the fabric, a brightly colored one can stain the cover.
Rinse the cover with the hose two or three times.
Turn the cover inside out and repeat the wash and rinse.
Take it off, then spread it out or hang it on a clothesline until it's completely dry.
Air dry only. Spread the cover out or hang it on a clothesline, and leave it until it's completely dry, inside and out. Don't put it in a clothes dryer.
Wait until it's dry before you fit it or put it away. It goes back on only a clean, dry jet ski once the exhaust has cooled (see how to put on a jet ski cover). To pack it away, see how to fold and store your cover.
For bird droppings and tree sap, soak the cover in warm water first to loosen them, then wash it by machine or by hand as above. If a mark won't come out, contact us.
For dust between washes, shake the cover out with the wind at your back, or go over it with a vacuum cleaner.
Trailerable Cover
AllGuard Weatherproof Shield Jet Ski Cover (Trailerable)
Water-resistant 600D solution-dyed polyester with a PU-coated back, an elastic hem cord, built-in buckles and straps, and air vents to aid trailering.
4 colors: Blue / Black, Gray / Black, Red / Black, Yellow / Black
$139.99
Shop the Weatherproof ShieldWe don't publish a mold or mildew removal method for our covers. What we do say: store a cover only when it's completely dry. If a stored cover smells musty, hang it up and let it air dry fully before you use it or bag it again. If you find mold on your cover, contact us.
For water that collects on the jet ski under a cover, see water pooling and moisture under your cover. For mold on the seats, see how to clean jet ski seats and remove mold.
Both covers carry a Lifetime warranty. See all our jet ski covers, or find more answers in the help center.
Check the care label first. If it allows machine washing, use a commercial washer with no center agitator, like the machines at a laundromat, not a household washer. Wash the cover in cold water on the delicate cycle with a mild detergent, run an extra rinse, then let it air dry.
No. Air dry it only: spread it out or hang it on a clothesline until it's completely dry. Don't use a clothes dryer, hot water or fabric softener.
Soak the cover in warm water first to loosen them, then wash it by machine or by hand with a mild detergent. If a mark still won't come out, contact us.
We don't publish a mold removal method for our covers. Store the cover only when it's completely dry, let a musty-smelling cover air dry fully before you use it or bag it, and contact us if you find mold on it.
At least twice a year: once when you take it off for the riding season, and again before it goes back on at the end of the season. Between washes, shake the dust off or vacuum it.
The Weatherproof Shield is water-resistant, not waterproof, and we don't publish a waterproofing spray or treatment for it. The Satin Shield is an indoor cover. Care for either one the same way: a mild detergent, no softener or harsh detergents, and air drying.
Measure your jet ski bow to stern in a straight line, then enter the length in inches.