AllGuard Weatherproof Shield
Outdoor storage and trailering
$139.99
Lifetime WarrantyStorage
Measure the door and the depth first. Then plan the floor space, check your owner's manual before standing the craft on end, and keep the engine off indoors.
Keeping a jet ski in a garage comes down to three checks: whether the rig fits through the door and inside, how to use the floor space, and what the owner's manuals say about storing a craft indoors and running its engine. This guide takes them in that order, then covers the cover. For the other places to keep a jet ski, start with our jet ski storage guide.
Only your own tape measure settles it. Take three measurements of the garage: the clear width of the door opening, jamb to jamb; the floor depth from the closed door to the back wall or the first obstruction; and the height of the open door and its track. Then compare them with the same three for the loaded rig. Our guide to jet ski trailer size and dimensions walks through each measurement.
A craft's overall length is on its maker's spec page. Here are current figures from Sea-Doo, Yamaha and Kawasaki. The same number sizes the cover, and the table shows the size each length takes.
Lengths are the manufacturers' published figures. Your measured length is what counts, and "measure to confirm" marks lengths within 1 in of a size line.
Five of these sit within 1 inch of a cover size line: the Yamaha JetBlaster, the Kawasaki ST 160 and STX 160LX, the Sea-Doo GTX and the Yamaha FX HO. If yours is one of them, measure to confirm before you order a cover. Off the trailer, on a dolly or a stand, the craft's overall length is the length to plan floor space around.
On its trailer, the rig is longer and wider than the craft. In our dimensions guide's tables, the Karavan and Yacht Club single PWC trailers measure 148 to 173 inches long (12 ft 4 in to 14 ft 5 in) and 56 to 65 inches wide. Their full-size doubles measure 184 to 203 inches long (15 ft 4 in to 16 ft 11 in) and 96.5 to 101.5 inches wide. Overall length includes the tongue: ShoreLand'r's 2015 PWC brochure, for one, lists two overall lengths for the same single trailer, one with a short tongue and one with a long tongue. If the craft overhangs the back of the trailer, measure the loaded rig from the coupler tip to whatever sticks out farthest.
Two published figures give a sense of scale. Daly City, California's 2019 single-family parking guide sets minimums for a new one-car garage there of 10 feet wide and 19 feet deep inside, with an 8-foot-wide door. For a new side-by-side two-car garage it sets 17 feet wide, 19 feet deep and a 14-foot door. Sheds Unlimited, a garage builder, frames its single-car garage kits for a 9 x 7 ft door, or 8 x 7 ft on its 10-foot-wide kits. Here's how the trailers above compare with those figures.
| Garage figure | Karavan and Yacht Club singles: 148 to 173 in long, 56 to 65 in wide | Karavan and Yacht Club full-size doubles: 184 to 203 in long, 96.5 to 101.5 in wide |
|---|---|---|
| Depth: 19 ft (228 in), Daly City one-car and two-car minimum | 55 to 80 in to spare | 25 to 44 in to spare |
| Door: 8 ft (96 in), Daly City one-car minimum | 31 to 40 in to spare | 0.5 to 5.5 in too wide |
| Door: 9 ft (108 in), Sheds Unlimited single-car kit | 43 to 52 in to spare | 6.5 to 11.5 in to spare |
| Door: 14 ft (168 in), Daly City two-car minimum | 103 to 112 in to spare | 66.5 to 71.5 in to spare |
By that arithmetic, each of those Karavan and Yacht Club singles clears both one-car door sizes with room to spare. Each of their full-size doubles is wider than an 8-foot opening, and a 9-foot opening leaves 6.5 to 11.5 inches before any room to steer it through. Depth goes fast too: a 19-foot garage leaves 25 to 44 inches behind one of those doubles, before any overhang of the craft and anything stored against the back wall. Daly City's guide, for one, treats a water heater, furnace, washer or dryer as taking 36 inches out from the wall.
Height is the third check. Both Sheds Unlimited door openings are 7 feet (84 inches) tall, and none of the trailer pages in our dimensions guide lists the height a trailer adds under the craft. Measure the loaded rig from the floor to its highest point, with the cover on.

If the rig won't fit, the craft alone still might: the next section covers dollies. If the garage won't work at all, see can you store a jet ski in a storage unit?
Taking the craft off its trailer saves floor space: the length to plan around becomes the craft's own overall length instead of the trailer's.
C.E. Smith's PWC dolly is one maker's example. It uses galvanized steel tubing on 4-inch casters, topped with 4-foot carpeted bunks that can be set 12, 16 or 20 inches apart. It measures 34 by 48 inches and has a 1,000 lb capacity. C.E. Smith describes it as a way to move a small vessel such as a jet ski around on any hard surface and into a storage space.
Check a dolly's capacity against your craft's weight with fuel, not its dry weight. Sea-Doo lists the 2027 GTI at 741 lb dry, before its 18.5-gallon tank is filled. Kawasaki lists the 2026 Ultra 310LX at a curb weight of 1,137.8 lb, which Kawasaki says includes a full tank of fuel (more than 90 percent of capacity); that's more than the 1,000 lb rating above. Our guide to how much a jet ski weighs covers more models. Follow the dolly maker's instructions.

A rack that lifts a craft off the floor, or stacks one craft above another, has to carry the craft's full weight. If you're weighing one, compare the rack maker's rated capacity with your craft's weight with fuel, and check how it supports the hull. Any rack or tilt setup that stands the craft on end runs into the warning in the next section.
Racks also earn their place for the gear. Life jackets, tow ropes and cleaning supplies take up floor space that a wall rack or shelf gives back.

If the craft lives on a dolly, the trailer still needs a spot. Karavan lists its Single Watercraft Steel and Single Watercraft Aluminum trailers at 212 and 250 lb empty. Before you stand an empty trailer on end or on its side to save floor space, ask its maker whether the frame is meant to sit that way and how to secure it so it can't tip. More off-trailer setups are in how to store a jet ski without a trailer.
Standing a craft on its stern, on a tilt rack or a tilted trailer, saves floor space. Yamaha's 2026 owner's manuals warn against storing a WaveRunner that way.
Important
Yamaha: store it upright and horizontal
All nine of Yamaha's 2026 U.S. owner's manuals print this WARNING in their long-term storage section: "Always place the watercraft upright in a horizontal position when storing it, otherwise fuel could leak out into the engine or engine compartment, which could create a fire hazard." Follow the storage position in your own owner's manual.
That warning is Yamaha's, written for its WaveRunners. Owners of other makes should look for the storage position in their own manual, and ask a dealer if it doesn't give one, before trying any rack or tilt setup that stands the craft on end. Our jet ski storage guide also says to check your own manual first. The makers don't describe the stored position the same way, and our guide to storing a jet ski outside compares what each one says.
Standing the empty trailer on end, with the craft off it on a dolly, is a different question, and one for the trailer's maker (see above).
A garage keeps the weather off; it doesn't replace the storage prep. BoatUS's winterizing guide puts it plainly: wherever you keep your boat, if you don't plan to use it for a month or more, you need to winterize it. Yamaha's 2026 manuals say storage for long periods, such as winter storage, requires preventive maintenance, and that it's advisable to have a Yamaha dealer service the craft first. Sea-Doo's 2026 guide recommends having the craft serviced for storage by a dealer, a repair shop or a person of your choosing, and lists the steps an owner can do.
The steps themselves, from fuel and flushing to the battery and freeze protection, differ by make, so they live in our winterizing guides rather than here: how to winterize a jet ski, with make-by-make versions for Sea-Doo, Yamaha WaveRunners and Kawasaki. For where it sits until spring, see jet ski winter storage.
Three points from the makers' storage sections matter more indoors:
Sea-Doo's 2026 GTX guide names the garage directly, and Yamaha's and Kawasaki's 2026 manuals warn against enclosed areas. Here's what each one says.
Kawasaki's 2026 STX 160 manual includes this in its storage steps: “Cover the watercraft and store it in a clean, dry place.” For a garage, the Satin Shield is our indoor cover: a stretch fabric of 85% polyester and 15% spandex with a sheared fleece interior, elastic front and rear hems, and reinforced pocketed grommets on both sides. It comes in two sizes, PWC2 - 2-3 Seater, up to 117 in, and PWC3 - 3-4 Seater, up to 138 in. Choose by measured overall length, not the seat count in the name.
If your craft measures more than 138 in, choose a Weatherproof Shield size instead; those run to P6 - 145 to 160 in. In the table above, that's the Yamaha FX HO, the Kawasaki Ultra 160LX and the Sea-Doo Explorer Pro. The FX HO, 1 inch over the line, is one to measure.
The Weatherproof Shield is our outdoor and trailering cover: water-resistant 600D solution-dyed polyester with a PU coating, an elastic hem cord, built-in buckles and straps, and air vents to aid trailering. It's sized from P0 - Up to 90 in to P6 - 145 to 160 in. If the craft leaves the garage on its trailer, it's the one sold as a trailerable cover; the Satin Shield is an indoor cover. Both are in our jet ski cover collection, and both carry a Lifetime warranty.
Measure first: our guide to measuring a jet ski for a cover shows how, and the size guide matches the number to a size.
Indoor Cover
AllGuard Satin Shield Indoor Jet Ski Cover
For a garage: indoor stretch cover in 85% polyester and 15% spandex, sheared fleece interior, elastic front and rear hems. Two sizes, for craft up to 117 in and up to 138 in long.
Color: Black
$129.99
Shop the Satin ShieldTrailerable Cover
AllGuard Weatherproof Shield Jet Ski Cover (Trailerable)
For a craft longer than 138 in, or one that leaves on its trailer: water-resistant 600D PU-coated polyester, air vents to aid trailering. Seven sizes by overall length.
4 colors: Blue / Black, Gray / Black, Red / Black, Yellow / Black
$139.99
Shop the Weatherproof ShieldEvery cover here is sized by overall length. Measure bow to stern, then match the number in the size guide.
It depends on the rig, so measure. In our dimensions guide's tables, the Karavan and Yacht Club single trailers are 148 to 173 inches long and 56 to 65 inches wide, and their full-size doubles are 184 to 203 inches long and 96.5 to 101.5 inches wide. Compare those with your door's clear width, the floor depth and the door height, and add any overhang of the craft.
It depends on the trailer and the garage. Daly City's 2019 parking guide sets minimums for a new one-car garage there of an 8-foot door and 19 feet of depth. By our arithmetic, the Karavan and Yacht Club single trailers in our dimensions guide clear an 8-foot opening by 31 to 40 inches, but every full-size double in those tables is wider than 8 feet. Measure your own door, depth and height.
Check your owner's manual first. All nine of Yamaha's 2026 U.S. owner's manuals warn: "Always place the watercraft upright in a horizontal position when storing it, otherwise fuel could leak out into the engine or engine compartment, which could create a fire hazard." For other makes, follow your own manual, and ask your dealer if it doesn't say.
BoatUS says that wherever you keep a boat, if you won't use it for a month or more, you need to winterize it. Yamaha's 2026 manuals say long-term storage, such as winter storage, requires preventive maintenance. A garage keeps the weather off, but the prep still applies; our winterizing guides cover it by make.
No. Sea-Doo's 2026 guide says never to run the watercraft in poorly ventilated or partially enclosed areas such as a garage. Yamaha's 2026 manuals say never to let the engine run for any length of time in an enclosed area, and Kawasaki's 2026 STX 160 manual says not to run it in enclosed areas. Run it outside, in the open.
Kawasaki's 2026 STX 160 manual includes "Cover the watercraft and store it in a clean, dry place" in its storage steps. Our Satin Shield is an indoor stretch cover for craft up to 138 in long; for a longer craft, choose a Weatherproof Shield size instead.
Yes, if the dolly is rated for the weight. C.E. Smith, for example, describes its PWC dolly as a way to move a small vessel such as a jet ski around on any hard surface and into a storage space, or as a vessel display platform, and gives it a 1,000 lb capacity. Check the capacity against your craft's weight with fuel, and keep the craft in the position your owner's manual gives.
Measure your jet ski bow to stern in a straight line, then enter the length in inches.